Physical Object: Connected Vehicle Roadside Equipment

RSE Device Management

Overview

'RSE Device Management' provides executive control and monitoring of the RSE hardware and installed software applications. It monitors the operational status of the hardware and other attached field devices and detects and reports fault conditions. A back office interface supports application installation, upgrade, and configuration as well as remote control of the operating mode and hardware configuration settings and initiation of remote diagnostics. A local interface is provided to field personnel for local monitoring and diagnostics, supporting field maintenance, repair, and replacement.

This functional object is included in the "Connected Vehicle Roadside Equipment" physical object.

This functional object is included in the following service packages:

This functional object is mapped to the following Functional View PSpecs:

Requirements

# Requirement
01 The field element shall monitor the operational status (state of the device, configuration, and fault data) of connected sensors (such as traffic, infrastructure, environmental, security, speed) and devices (such as highway advisory radio, dynamic message signs, automated roadway treatment systems, barrier and safeguard systems, cameras, traffic signals, ramp meters, short range communications equipment, security surveillance equipment).
02 The field element shall send operational status of connected field equipment to the maintenance center.
03 The field element shall send collected fault data to the maintenance center for repair.
04 The field element shall include a local interface that provides operational status and fault data for connected field equipment to field personnel.
05 The field element shall include a local interface that allows field personnel to command diagnostic tests on connected field equipment.
06 The field element shall provide operational status information to the Service Monitor.
07 The field element shall implement configuration commands received from an authorized Center.
08 The field element shall implement operational status commands received from an authorized Center.
09 The field element shall implement operational status commands received from authorized Field Support Equipment.
10 The field element shall implement configuration commands received from authorized Field Support Equipment.

Standards

Currently, there are no standards associated with the functional object itself though the interfaces may have standards associated with them.