Physical Object: Traffic Management Center
TMC Dynamic Lane Management and Shoulder Use
Overview
'TMC Dynamic Lane Management and Shoulder Use' remotely monitors and controls the system that is used to dynamically manage travel lanes, including temporary use of shoulders as travel lanes. It monitors traffic conditions and demand measured in the field and determines when the lane configuration of the roadway should be changed, when intersections and/or interchanges should be reconfigured, when the shoulders should be used for travel (as a lane), when lanes should be designated for use by special vehicles only, such as buses, high occupancy vehicles (HOVs), vehicles attending a special event, etc. and/or when types of vehicles should be prohibited or restricted from using particular lanes. It controls the field equipment used to manage and control specific lanes and the shoulders. It also can automatically notify the enforcement agency of lane control violations.
This functional object is included in the "Traffic Management Center" physical object.
This functional object is included in the following service packages:
- PT10: Intermittent Bus Lanes
- ST07: Eco-Lanes Management
- TM22: Dynamic Lane Management and Shoulder Use
- VS10: Restricted Lane Warnings
This functional object is mapped to the following Functional View PSpecs:
- 1.1.2.10: Provide Dynamic Lane Management
- 1.1.2.9: Monitor Dynamic Lanes
- 1.1.4.1: Retrieve Traffic Data
- 1.1.4.2: Provide Traffic Operations Personnel Traffic Data Interface
- 1.2.2.1: Determine Indicator State for Freeway Management
- 1.2.2.2: Determine Indicator State for Road Management
- 1.2.3: Determine Ramp State
- 1.3.2.1: Store Possible Incident Data
- 1.3.4.2: Provide Traffic Operations Personnel Incident Interface
- 1.4.1: Provide Traffic Operations Personnel Demand Interface
Requirements
# | Requirement |
---|---|
01 | The center shall remotely monitor and control dynamically managed travel lanes. |
02 | The center shall monitor traffic conditions and demand measured per lane. |
03 | The center shall receive input from Border Inspection Systems to identify existing and planned lane configurations at the border. |
04 | The center shall receive input from multimodal crossings such as draw bridges to identify existing and planned lane configurations at the crossings. |
05 | The center shall receive input from an Intermodal Terminal to support monitoring and anticipation of commercial vehicle traffic originating at the depot and requests for dynamic lane management in the vicinity of the depot. |
06 | The center shall monitor and coordinate dynamic lane controls with adjacent jurisdictions. |
07 | Based on the collected data and operator input, the center shall determine suggested and required lane control configuration changes. |
08 | The center shall support temporary use of shoulders as travel lanes. |
09 | The center shall activate lane management field equipment that is used to dynamically manage specific lanes and shoulders. |
10 | The center shall identify lane use restrictions, prohibiting specific types of vehicles (e.g., commercial vehicles) from specific lanes. |
11 | The center shall designate lanes for use by special vehicles only, such as buses, high occupancy vehicles (HOVs), or vehicles attending a special event. |
12 | The center shall receive environmental information from roadway sensors and connected vehicles to identify existing and planned lane configurations long the roadway. |
13 | The center shall optimize lane use restrictions for the environment. |
14 | The center shall reconfigure intersections and interchanges for compatibility with the current lane configuration. |
15 | The center shall notify the enforcement agency of violators of the lane controls. |
16 | The field element shall analyze collected vehicle and sensor emissions data against reference data, and determines whether or not an eco-lane should be created or decommissioned along a roadway. |
17 | The center shall accept requests for dedicated bus lanes from the transit center. |
18 | The center shall notify the transit center of dedicated bus lane status. |
19 | The center shall exchange device data, control and status information with other centers to facilitate dynamic lane management. |
20 | The center shall exchange device data, control and status information with other centers to facilitate dynamic lane management. |
Information Flows
Standards
The following table lists the standards associated with the functional object itself (as opposed to standards associated with an interface).
Name | Title |
---|---|
NEMA TS 8 Cyber and Physical Security | Cyber and Physical Security for Intelligent Transportation Systems |